Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hoping someone could lend a further hand on this issue, using ISE version 2.4
Working on trying to add the option in Cisco ISE Guest Registration portal where rather than the end user having to type in the sponsor's email address there is a dropdow...
Hoping this has happened to someone else and they can shed some light on the subject. I have a CUCM 9.1.2 cluster running, pub, 2 subs, and 2 tftp servers. At the moment it's a small deployment so I have all phones registered to sub 01 as primary a...
All,Recently installed click to call 8.0 on my Windows 7 64bit machine. When I go to set preferences in the click to call application, name, password, relevant servers it appears to take the information. I think click save and the next time that I ...
I'm running into an issue where my client connects to a specific wlan using EAP-FAST as the EAP method and am using automatic PAC provisioning, initially everyting is working fine but the connection strength goes from excellent, to poor, then to netw...
I'm currently in the process of configuring multiple 4402 controllers and have a quick question concerning the virtual interfaces on them. According to Cisco they should have a unique ip address assigned to them typically 1.1.1.1. My question is th...
I actually did capture the console log off one of the phones, see attached. I don't have the relevant cucm traces. Looking through the console logs it does look to me that the issue is certificate related but the TAC engineer didn't seem to think t...
Also to add, it wasn't all phones some would re-register just fine and I can't find any correlation between the ones that did and the ones that didn't. Thanks again.
I ran into this as well. There is a bug with the 4.2.176 version of code. It is referenced in CSCsv77075. The issue has to do with https. After the upgrade you cannot connect to the wlc mangagment ip address via https. The workaround was either t...
