Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there,I need to implement hub-spoke multipoint L2 bridging solution over non-mpls IP only enterprise network. Is there any light VPLs or similar technologies that I can use without implementing full blown MPLS. Is there any way to modify l2tpv3 to...
Does anyone know the port distribution to different ASICs in 3560E ? I can see three ASICs in the show command ? Switch#sh platform port-asic versionPort-Asic Version Info:========================ASIC-0: Version:3 DeviceType:0x2ABASIC-1: Version:3 De...
Is there any possobility of problem if LAN side of inline group is set to 1Gb but WAN side is only 100 Mbps ? Also I can not see LAN and WAN settings in WAE-512K9 of 4.0.13 although this is clearly shown in 4.0.7 configuration of of 511.How would I ...
How do we clear connection stats in monitoring option in WAE ? I went to CLI and run "clear statis all" but could not clear "connection summary table" in "monitoring" display.thanksSerhat
sorry, forgot to mention that this is 48 port switch i.eSwitch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 54 WS-C3560E-48PD 12.2(35)SE5 ...
Zach,The connection has been dropped so many times but the first two connections stayed in the display. In the central device there are some connections that show 200 hours uptime certainly not correct especially after the connection recycled severa...
Okay I have found the status of the ports in the system file as below;Nov 6 14:28:42 waasnz1 Sysmon: %WAAS-SYSMON-3-445010: Fault detected: InlinePort 1/1/wanNov 6 02:16:32 waasnz1 kernel: %WAAS-SYS-3-900000: e1000bp: eth2: e1000bp_watchdog: NIC Li...
sh int ? shows these ;waasnz1#sh interface ? FibreChannel Display information for FibreChannel device GigabitEthernet Display information for GigabitEthernet device ide Display information for IDE interface InlineGroup Select a...
