Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
G'day allCisco C1117-4PWECisco C1117-4PWE Built-In NIM controllerVADSL_A - Multi-mode xDSL with VDSL and ADSL1/2/2+ Annex A over POTSWireless LAN ModuleCisco IOS XE Software, Version 17.09.08I had some spare cash, so purchased a second hand C117 off ...
Hi folks, We have a ASA on 9.12(4)67. There is an ONT that is connected on the external interface and we use DHCP to retrieve our IP and gateway etc. for out internet connection. If this interface drops and then recovers (ONT is in a different room ...
G'day Folks. ASA 5515 (9.12(4).67) and an SG200 24P (1.4.2.4)Is anyone aware of issues why an ASA gig0/0 inside interface only netgotiates 100MB when connecting to a Cisco SG200 SME switch?The ASA outside interface gig 0/5 and is fine and reaches gi...
Hello !I have two AP3800s, One as an ME, one as CAPWAP. Both are using latest release and the ME, has had a factory reset... Both indicate running at full power via PoEI am using two SG350-10MP s in a disy chain (the middle swtich is an SG350SFP) ,...
Good Morning, Thank you for the follow up, and can confirm the script worked nicely. yes, we could do 9.14(4)24, but that's for another day when I have more £ in the budget later this year. Mark
Hi Again, 1) We loose internet access. The interface goes down, then returns to up as connection is regained to the ONT. (The ONT is not on a UPS, so if there is a power interruption, it has to re-initialise. Hence the interface going DOWN-UP. The AS...
Hello, Here's some example syslogs.2025-11-19 03:40:12 Gig-0/5-External <IP> ifAdminStatus: down -> up System2025-11-19 03:40:12 Gig-0/5-External <IP> ifOperStatus: down -> up System2025-11-19 03:35:10 Gig-0/5-External <IP> ifAdminStatus: up -> down ...
Managed to get to Site today...ok, as per normal It was something simple,A faulty brand new network cable was the cause, noticed a small microscopic crack up by the head of the mold of the RJ45...
Thank you for the replies, I did try quite a few combinations, including forcing at the switch end to only gigabit and full duplex, I'll be back at site at end of week and will have another play...I'm quite aware that the kit is EoL, but as mentione...
