Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I need to setup a VACL in order to capture all vlan 119 SIP and RTP traffic across multiple switches (6509`s and POE 3560`s) and output this to a single port off one of the 6509`s.Can someone show me a working VACL for that type and where it sh...
Hi,Just aquired a 6509 which has a S2E (Sup 2) on slot 1 and a X6148-GE-TX on mod 3.It's running catOS 7.6I managed to reset the password and able to login on the console via the console port.I want to change the IOS to be CiscoIOS instead of catOS. ...
C6513 w/SUP720-3BThis is what I have in my SW1.I have 4 6500 series switches... I need to mirror several port and bring them to 1 device on 2 x 1Gb ports.I use RSPAN VLAN 1051 for SW1, RSPAN 1052 for SW2, RSPAN 1053 for SW3 and RSPAN 1054 for SW4.SW3...
how do you setup the management interface on the FWSM for ASDM management access seen that there is no loopback interface on the FWSM?Thanks in advance for the quick reply.
I beg to differ... I have the 2 sups in mod 1 and 2 :Router#sh modMod Ports Card Type Model Serial No.--- ----- -------------------------------------- ------------------ ----------- 1 2 Catalyst 6000 sup...
redundancy is configured, yet my 2 sup's, 1 is active and 1 is standby COLD. How do I make it standby HOT ? so not to cause network outage when it switches?Also, is there a command to force the switchover?
After the above, I read to change the confreg to 0x42 in order not to boot the load of the MSFC2 if it's missing... The bellow is what I get:rommon 9 > confreg 0x42You must reset or power cycle for new config to take effectrommon 10 > resetSystem Boo...
