Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are upgrading from a 2821 Router to a 4331 router and the commands are a little cryptic to me. Basically we have three vlans that need to have dhcp requests to the switches when individual devices on each vlan request an ip address and for some r...
I am showing significant drops in NAT reverse failure and trying to figure out where the issue is.
Show ASP Drop
Flow is denied by configured rule (acl-drop) 6676289
NAT reverse path failed (nat-rpf-failed) ...
We have a few 7962G phones that have gone bad and would like to upgrade to the 8841 phone which only allows SIP based protocol. Is there any issues installing these phones on the CME when it is already using SCCP as protocol for existing phones. Ro...
VPN Client connects and gets proper IP address, but cannot ping local servers or access local resources
Cisco AnyConnect Secure Mobility Client 4.2.01035 (Wed Feb 03 06:28:51 2016)
Connection InformationState: ConnectedTunnel Mode (IPv4): Split Exclu...
This was in the config (am I missing something):
!
zone security lan
zone security internet
zone-pair security net-self source internet destination self
service-policy type inspect to-self-pmap
zone-pair security priv-self source lan destination se...
We are showing issues within the network on connectivity. Primary NAS seems to work no issues when users on inside connection are using it only, but for some reason when a wireless user connects to it there then seems to be a lag for both the wirele...
I apologize when you say actual log what are you referring too? The response above is the complete response from "show asp drop"
Here is current:
asa5506# show asp drop
Frame drop: IPSEC tunnel is down (ipsec-tun-down) ...
This is after 10 seconds:
Frame drop: No route to host (no-route) 2 Flow is denied by configured rule (acl-drop) 198 First TCP packet not SYN (tcp-not-syn) 22 TCP RST/FIN out of order (tcp-rstfin-ooo) 1 Slowpath security checks failed (sp-security-fa...
