Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am looking for some help solving a problem with a Cisco 1921 and the Verizon 4G EHWIC card. I have configured the router and it is working and was looking to add the 4G as a backup to the primary connection G0/0. The cell interface is at C...
I don't believe it is the software as the three other people on this thread and using completely different versions, so that would not make sense that it is the software. Has anyone had luck figuring out what the issue might be? Browser? Does the ...
Yes they can work in autonomous mode you just have to download the appropriate software for autonomous mode and install on the AP then configure accordingly. -Fred
Same problem here with a 2702i using the following software: ap3g2-k9w7-tar.153-3.JK.tar You can save config changes in the CLI and it will show on the WebGUI but if you try to change anything and apply via WebGUI it faults with 404 error page not fo...
Here is a question you might be able to shed some light on. When I do a show arp, I not only get address for LAN but I get many from all different addresses but all the same MAC. I believe it should only show the internal LAN. Something miss confi...
