Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm seeking Cisco documentation to guide me in creating a traditional IPsec tunnel and an IPsec tunnel with GRE between a Cisco SD-WAN router and a Cisco non-SD-WAN router. Thanks a lot!
I am looking for some Cisco documentation to clarify a behavior I am noticing on the cEdge router. When I perform a clear sdwan control-connections command on the router, the RIB is rebuilt. This router is also running other routing protocols in the ...
Hi,I am experiencing an issue generating the packet capture file in vManage UI. After stopping the packet capture, vManage initiate a preparation of the file for download, but it gets stuck in the loading status until a 'Session timed out' error mess...
Hi GuysI am troubleshooting NTP connectivity and a sync failure using TCPDUMP. When I run the tcpdump interface X/X options "dst ip X.X.X.X" or tcpdump vpn X options "dst ip X.X.X.X", I don't see any traffic being sent out to the NTP Server. The TCPD...
Hi GuysI received a RMA from Cisco to replace an APIC Server (M2 Model). After unboxing the server and completing the setup with sucessfully. I encountered an issue with the OOB interfaces. The interfaces are not working and remain in a down status e...
Hi @MHM Cisco World Sure, let me try to provide more details.I have noticed that when the control connection goes down and comes back up, or when I manually perform a 'clear sdwan control-connections' command, the routes in the RIB are flushed and re...
@MHM Cisco World I configured NTP to use VPN 0, but I believe it is the default value and is not visible in the running-config. Anything other than VPN0 will be visible in the running-config.
Here are the details you requested.vEdge1# show run system ntpsystemntpparentno enablestratum 5exitserver 200.160.0.8version 4exit!++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++vEdge1#show ntp peer ...
Let me give you a heads up about the test.The vEdge is running in CLI mode, I enabled the "allow-service ntp" on the transport interface, but the tcpdump still doesn't show any NTP's traffic generated by the router.To troubleshoot, I decided to switc...
