Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team,
vrf already created, however I am not able to add a interface in a specific VRF.
Model: C1101-4P
Getting below error:
router(config-if)#vrf ?% Unrecognized commandrouter(config-if)#ip vrf ?% Unrecognized commandrouter(config-if)#ip vrf...
Hi All.
Getting the below alert, can some one help please how to metigate and reason of port flapping.
Interface TenGigabitEthernet0/0/11, link down due to MAC local and PHY line side fault. Transceiver Rx optical power is too low (-40.0 dbm)
Current ver - c1100-universalk9.17.09.05f.SPA.bin
Im geting below error
#int GigabitEthernet 0/1/2.150^% Invalid input detected at '^' marker.
Unable to create sub interface as well.
This is the output of #sh int Te0/0/1 transceiver
Can you please suggest what is the model of SFP.
Description = SFP or SFP+ optics (type 3)Transceiver Type: = 10GE SR (27)Product Identifier (PID) = SFP-10G-SR-SVendor Revision = 1.0Serial Number ...
