Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,I have an issue with VSS setup. The VSS setup act as a transit core switch for internet traffic and the problem arises when there are about 600 Mbps of traffic passing through the switch. We notice that there are a lot of packet being softw...
Hello Netpros!I have some issues that probably most of wireless implementers faced after implementing a wireless solution. This is an actual feedback from the customer and These issues can be broken down to the following:1. The wireless Network is sl...
Thanks for the quick reply. You don't watch football do you? Anyway, We have the sup 720 10 G with PFC3C. so i agree with you that it could not holds full internet route. Need to upgrade it to 3CXL.By your answer i am quite sure the steps that i will...
Hi jeff, if i am not mistaken, all wireless frames transmitted will be encrypted with the long key right? does having these long key will practically makes the frame longer?
Yup,thats what we told the customer and even showed them the wlc/wcs reports. Unfortunately, these customers are lacking in wireless knowledge and they want a streamlined, documented steps to generate the reports and also to help them understand in l...
Mirza,I build the topology i posted based on your diagram including the IP addresses, except for some loopbacks that were not there. I also remove the static route in R4. The bgp for vpnv4 only runs on r3, r5 and r6. r4 is a pure P router with no bgp...
Hi Mirzaak,I have built your topology and configure basic MPLS VPN by using 3600 routers on the core (r3,r4,r5,r6) and 2600 for the CEs. But since i want to do it very quickly, i did not use any frame relay switch, so all serial are back to back hdlc...
