Is it possible to assign a public IP address to the physical interface of a server that resides on the DMZ of a ASA 5505?I have a server requirement to avoid NAT and assign a public IP address directly to the interface.  Is this possible while the se...

We are using an 871 for a remote office. We need to allow contractors the ability to establish a PPTP tunnel to an outside Windows server. I do not administer the PPTP server, I only need to understand how to allow PPTP traffic thru the 871. Any s...

We are running a Cisco ASA 5505 and remote clients are 871's. We currently use a EasyVPN configuration between the single ASA and our 13 871's. Today (1) out of the (13) tunnels is experiencing packet loss. I have power cycles the broadband router ...

I am very new to configuring Cisco WLAN's and I am aware that this is most likely a very basic question. I would like to use (2) Cisco 1131's in the same office to obtain total WLAN coverage of the office. What is the best way to accomplish this?

I am using Cisco 871's with Advanced IP Sec IOS for remote offices. I need to allow IPSEC traffic to pass thru the 871 to establish a client IPSEC tunnel. The client VPN software is Nortel's Contivity VPN. How can I allow IPSEC traffic to pass thr...