Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Below is the output from the above command:1-001d.e049.f5a7 pak in 25 bytes in 3272 pak out 8 bytes out 1364 dup 0 decrpyt err 0 mic mismatch 0 mic miss 0 tx retries 0 data retries 0 rts retries 0 signal strength 72 signal quality 27Bu...
HiCall managed 6.1.2.1000-13I have a profile using extention mobility and that profile is logged into a phoneI am struggling to find which phone this profile is logged into?I cannot look at the back of the phone for the mac as I am remote - but unabl...
Hi can any one give advice on how to configure the 2nd port on an ATA 186Port 1 works fine - but wanting to set up port 2 - I read that you have to take off the first two digits of the mac and pot 01 at the end?e.g. 00-ff-ff-ff-ff-ff and replace with...
Bit of an old version for you.....! call manager version 3.3 - where do you assign rights to user profiles? e.g. full rights, read rights, no rights?user 1 = full rights to change everythinguser 2 - to see what is in a profileuser 3 - has no rights a...
Call Manager 4.2 - phone 7941i have 48 phones into a switch and all work fine apart from about 5 users. They are unable to hear anything but the caller can here themThe switches, gw and call manager has all been rebooted and the interfaces have been...
No templates was lost as far as I could see - there was a conflict with 2 bat files - unintalled them both installed the latest one and that worked fine
