Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Created a new vlan10 for managment and and assigned 10.74.2.3 255.255.255.0 to that vlaninterface Vlan10description MGMT_VLANip address 10.74.2.3 255.255.255.0sh ip int briefInterface IP-Address OK? Method Status ProtocolVlan1 unassigned YES NVRAM up...
I am testing FortiSwitches on our network, I have a 224e that I am trying to trunk directly to an ethernet port on my cisco 9300. I have trunked the port on my cisco port 36 interface GigabitEthernet1/0/36description Uplink to Fortiswitchport trunk a...
Based on the route configurations below, I am having issues getting to the next hop. I recently created a 10.78.x.x network that needs to follow the same as the 10.76.x.x network which currently works. I need both of these to be able to hit anything...
I am trying to setup my router to sla so that when my comcast isp is down my secondary ip will take over. I am having issues because my comcast although I pay for 5 static ip's I am unable to put into bridge mode per comcast. I'm not sure what I woul...
So I do have a trunk port assigned already to carry traffic to other switches but each switch has it's own third octet for management ie: 10.74.2.x next site 10.74.4.x next site 10.76.6.x etc. This is what I have configured right now for port 1 our t...
And this is what I get when I put ospf back in and remove eigrpTracing route to dns.google [8.8.8.8]over a maximum of 30 hops:1 <1 ms * 1 ms 10.76.10.12 1 ms * 1 ms 10.76.10.13 10.76.10.1 reports: Destination host unreachable.
Here's what i get when I enable eigrp and remove ospf, internet works how it's supposed to. I did nothing else other than remove ospf and paste back in original eigrp rule1 <1 ms <1 ms <1 ms 10.76.10.12 3 ms 3 ms 3 ms 10.76.200.403 2 ms 2 ms 2 ms 10....
