Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Might anyone have procedures for setting up nvram:startup-config "restore points"?
Such as having local storage (onboard 9800WLC, for example) of nvram:startup-config_bk1, nvram:startup-config_bk2, nvram:startup-config_bk3
And then, as desired, overw...
In particular, I am running a 5508 WLC version AIR-CT5500-K9-8-0-121-0.aes. "show run-config" provides all items Enabled but no indications of items Not Enabled. Can a full set of all configurable parameters be retrieved whether Enabled or Disabled...
The strategy I settled on was to begin with a baseline representative startup-config file, then use CLI commands to ftp desired startup-config onto WLC and then reboot. Sure, the drawback is the need to reload the WLC. But, a big advantage is the con...
I am not seeing "transfer" as a valid command in either privileged or non-privileged on 9800WLC Version 17.08.01Are there equivalent CLI means to complete the GUI means for ftp upload/download of startupconfig and runningconfig ????Thanks in advance....
Hi everyone, I follow these steps with 17.8.1 and I end up with error messages to the effect... "Channel cannot be modified via CLI" and "Transmit power cannot be modified via CLI" Any advice?
