Hi Have a problem with a Cisco ISR4331 router (image isr4300-universalk9.16.09.05.SPA.bin).1. Successfully uploaded configuration using SCP2. Router reboots and loads new configuration3. Configuration is successfully applied, but there are no shutdow...
Thank you all for your help! Problem is solved. Probably the thing was that there was not
ip address
command specified. If it is, ports are successfully enabled after startup.
I also see administratively down in
show ip interface brief
and message on startup:
SETUP: new interface GigabitEthernet0/0/0 placed in "shutdown" state
