Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Guys,I am facing issue with ip sla in the configurations that I configure. My aim is that the traffic from vlan 1 should always reach 8.8.8.8 even if the connection from R1 to Internet 1 is down. I have post the configs of all the devices out h...
Hello Guys,I have this network where i need if x side is down then the traffic should go from y side. I am using OSPF and have check the routing table but I don't know where did i make a mistake. Can someone please correct me?
Hello guys I have this topology where the inside network runs with ospf and in the ftd there is both default route and ospf ?After configuring all this also my inside network cannot go to the internet or the isp ip.My question is how do i redistribut...
Hello Guys ,I have this problem with the FTD where I can't assign ip to the interface or deploy anything when i check the status its showing this can someone please explain what is this and how do i solve it? Do I need to update or what ?
@MHM Cisco World Still not working with only this command alsorouter ospf 1log-adjacency-changesnetwork 0.0.0.0 255.255.255.255 area 1default-information originate
@MHM Cisco WorldI cannot remove the default route since I have to advertise the default route which is the routing protocol I have to use if i want to route with the isp.
