Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This touches VoIP stuff, but it's really a LAN issue as I see. I'm using Polycom IP430 and IP600 series phones against Interactive Intelligence EIC 3.0 server. These phones pull DHCP from a Win2008 DHCP server. DHCP settings give out Option 066 to...
A few months ago, I moved back into one of my buildings where the entire building is ran through a 6513 with Sup2/PFC2/MSFC2. This switch is in hybrid mode and the Supervisors are on 8.5(4) yes, I know it's old and hybrid mode has gone the way of th...
hardware setup is as follows:2 x UCME (SystemA and SystemB) with a single PRI connected to SystemA. SystemB will be new to the environmentSystemA and SystemB can exist on the same VLAN's if necessary, or they can be entirely separate VLAN's with rou...
I am trying to setup a translation-rule for all international calls (011) so that the type is changed to unknown. I need this to interface properly with my telco.I've created the translation-rule fine as verified by the test command, but getting it ...
Hello all, I need some assistance setting up an international dial peer on a UCME system.Users are required to prefix outbound calls by dialing "8", but the 8 is not necessary to actually make the call over the outbound PRI. This is strictly an inter...
Bumping this thread up again, still having this issue. I updated the Sup2's to CatOS 8.6(4), which is latest release available, but no help.Recap:if I define auxiliaryvlan, the IP phone pulls an IP from DHCP server on the auxiliaryvlan. IP Phone ca...
ip helper is active on VLAN 3. as I can confirm on the phone, it's being told what VLAN to go on by CDP, but cdpverify seems to not acknowledge that the device is actually a PHONE. As I read the docs, cdpverify only makes the auxiliaryvlan active i...
Using my new vlan 3, I did "set port auxiliaryvlan 13/2 3 cdpverify enable" and rebooted my phone.The phone "about" page shows VLAN 3, but it shows "resolving" for address and boot server. The phone appears to ne unable to pull an IP address from th...
set port auxiliaryvlan 13/3 53with "cdpverify enable", the switch never sets the auxiliaryvlan to active with the phone plugged in, so I have to set cdpverify disable. This is the only way the phone ever goes onto the auxiliaryvlan. Wireshark logs...
The problem occurs ONLY when I define auxiliaryvlan on the switch. If auxiliaryvlan is NONE, I can put the port on ANY VLAN (including 53, where the server is), and everything is fine.As you suggested, I created an entirely nerw VLAN on a different ...
