Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Working with 2 Catalyst 6509 conected via a LACP with 4 ports 1G obtain a very imbalanced traffic distribution. The etherchannel is working with default configuration.The traffic flow is from clients to servers and the clients begin the connection.
An etherchannel link between 2 Catalyst 6509 with IOS 12.2(18)SXE5 the interfaces have overrun frames. The connection is done with 4 ports 1G of WS-6548-GE-TX modules installed in every of any 6509. ¿Do you know how can solve these overrun frames?I`...
Hi all,We have installed the LMS3.0. The devices in DFM are in Questioned>Other state with the following error code:"Data Collector Timeout". Although the devices were rediscovered, in the learning state still remain at the 40% rediscovered.I found i...
Working with Catalyst 2960 IOS IOS 12.2(40)SE, when confire "storm-control multicast level 30" on ports 1000Base-SX some times the port goes to err-disable state with a log message of multicast storm on port.The level of multicast traffic on this por...
Working with CATOS on Catalyst6506, is there any way to identify between a fan-try WS-C6K-6SLOT-FAN and a WS-C6K-6SLOT-FAN2? there is?nt this code part number in the part.Is there any catos command to identify the fan-try type?
Hi Glen,Thanks for your input.Wich are the other methods?. We are thinking about modify the load-balancing keywords(src IP, src Mac....).In every etherchannel 4G we are using only perhaps 1,5M and some times have overrun frames on the interfacesThank...
Hi Mark,The link with overruns is part of a group of 6 Catalyst 6509 witch are doing level 2 only. The level 3 for routing inter-vlans and other IP routing is done by an external system.The document you sent to me refer a by default value of 75, a ma...
