Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 2960 switch that is not allowing me to setup switchport trunk encapsulation dot1q on a trunking interface. The show capabilities shows that the interface can use 802.1q, but when I try to CLI the command the work encapsulation is not a...
I have upgraded a Tandberg E20 TE2.1.0 to TE4.1.1 (no encryption) Phone is now showing up in both Data & Voice/Video VLANS. It appears that the Data and Voice traffic is being properly handled, due to the fact that when I SHUTDOWN the voice/video VL...
HI, I am CCNP, but a VOIP newbie, just took a new job. Therefore first VOIP LAN.I have upgraded my LAN using WS-C3560X switches. I am upgrading 60 Tandberg E20 Video Phones from TE2.1.0 to TE4.1.0 due to the E20 not finding the voice vlan.I am usin...
Hi,
I am a Project Manager (PMP) who is an x-Cisco CCNP. I was just laid off, so have spent my time learning about Duo Security.
Matt K. at Duo gave me access to the LevelUp training site and asked me to provide some feedback. If you are intereste...
Danny, I have done a "clear mac address-table dynamic" on the switch, with the same result as before. I have installed 8 E20 (TE 4.1.1) on Cisco 3560 switches, all of the phones show up on VLAN 100 and 11.Vlan Mac Address Type Ports 11...
FYI, I will be out of the office until Saturday, I will reply back at that time. Thanks for your time.Danny, I have not been able to login as admin or root. The release notes state that no password is set. Any Suggestion on how to login? I am using B...
