Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When VPN established I can Ping the Router but no other device on the network. From the Router I can ping all devices including my laptop that is connected. Here is the config......What am I missing? This is probably about the 100th one I have set...
I have a Cisco 1700 and was wondering it is was possible to configure as a T1 Pass Through? The customer is getting a T1 as a backup to our fiber- required by German corporate. They however, don't want to buy a different Router and want to still us...
Looking for hardware solution and software solution.Internal IP 10.10.10.xCustomer has 1 pt-2-pt and 1 DSL connection.Pt-2-Pt connection is the path to all of the Email Servers and File Servers on the other endThe New DSL connection they want to use ...
I have a C3600 that has no config on it. When I power it up I getC3600 processor with 65536 Kbytes of main memoryMain memory is configured to 64 bit mode with parity disabledloadprog: bad file magic number: 0x0boot: cannot load "flash:"System B...
Sorry I wanted to post my conclusion for this to help others. I ended up going on site and changing the the NAT information. I didn't want to do this remotely. Once I took out the other statements and added the below I was able to access all of th...
Thank you but that didn't work either.All of the other routers I have configured work just fine with the access-list like I have. I did give it a go but got the same results as before.
So you are sayingaccess-list 100 permit ip 192.168.0.0 0.0.0.255 anyaccess-list 100 deny ip any host 192.168.0.190access-list 100 deny ip any host 192.168.0.191access-list 100 deny ip any host 192.168.0.192access-list 100 deny ip any host 192...
