Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, thereHow can user B use a client certificate which is installed by user A in the local computer personal certificate store?When user A is connecting to VPN without problems on the other hand, user B is trying to connect to VPN receiving the error...
Hi, thereI'm using ASA5516 and Firepower 1140 as VPN Gateway with AnyConnect.I installed CA certificate which is generated by third party RADIUS on both ASA5516 and Firepower 1140.I also generated and install a client certificate for my computer.When...
Hi, thereASA Ver: 9.16(2)7ASDM Ver: 7.16(1)150We have three administrative users who can use ASDM.When one of them forces someone's user to logout.Is there any way to check who did it?Any advice would be appreciated
Hi,teams I'm new to Codec Pro and trying to connect a PC to Codec Pro by using HDMI cable.The video is displayed on the screen perfectly but the audio doesn't work.(no sound)I'm using HDMI 1 and this is what I set the configuration of HDMI 1. Softwa...
Hi,teams I'm new to ASA and replacing an old ASA5516 with Firepower 1140 as VPN Gateway with AnyConnect.The VPN configuration for AnyConnect is the same as on ASA5516.When I attempt to connect VPN by using AnyConnect, It failed.This is what syslog sa...
I looked into the logs and found the error ‘peer certificate key usage is invalid’What I did was to add ‘ignore-ssl-keyusage’It’s working nowThanks for your advice.
Hello BB,Thank you for your reply.I referred to the article down below.https://tayam-infra.net/how-to-configure-asa-for-certificate-based-authentication/I'm not really sure whether FTD including Root and chain or not because I don't use FMC.
Hello M,Thank you for your reply.When I use "show logging" , there are too many logs that I cannot figure out the logs that I want to check.Is there any command that I can check the logs easily?I found the logs.%ASA-6-725016: Device selects trust-poi...
Unfortunately It seems like there is no way to check who forces user to logout in my production network.I’ll consider using TACACS next time If I have an opportunity to build like this production network. Thanks a lot.
Thank you for the reply.I’m not running ISE in my production network and I’m not using the TACACS either.I’m using a third party appliance as the RADIUS.Is there any way to check the log (when who what) by configuring on ASA or ASDM?
