Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to monitor several OIDs in my stack of SG500's (not SG500X's). I can snmpwalk the switch and get a long list of available OIDs; but I need the associated list of OID labels to figure out what each OID value represents. The switch's interface...
Digital certs in my 2504 WLC's have expired and they need to be replaced. While I don't have a large number of AP's (currently old 2702's) and I understand that Mobility Express or Embedded Wireless Controller software would be a good fit for my sit...
I have a Yahoo-ATT DSL installation with 1 dynamic IP address. It uses an ISP supplied speedstream 4100 DSL modem. The 4100 appears to take care of all the PPOE duties and DHCP connections from PCs or low-end routers (I'm temporarily using a NetGea...
I have two 1811 routers, one acting as an Easy VPN server and the other acting as an Easy VPN Remote. After configuring the remote, I can test the tunnel from the remote end via SDM. It prompts for the Xauth user and password, establishes the tu...
I am configuring two 1811s (1811 and 1811W) and have run into the same problem on both. Configuration has started out with SDM, but debugging and "final" config is through the console.I have 4 private nets (192.168.1.1, .2,.3,.4) that are running on...
Thanks for the reply. I ran across that site earlier but was not aware it was originally populated by cisco. Good resource. Unfortunately, I could not find any mibs related to "small business" switches (in particular an SG500-28). Grep'd through ...
BTW, I'm surprized that there isn't a Cisco tech note on this exact problem. The 4100 (which I believe replaces the 5100b) is being shipped by lots of ISPs. And, I rarely seem to run into network problems that have not already been seen (and solv...
Thanks for the suggestion. The modem is in NAT mode w/PPOE performed on the modem. As I understand it, that's the only config ATT Yahoo supports. I have found info on how to change the 4100 to bridge mode; but, again as I understand things, that p...
Good point. I think you're right about SDM producing some really "obscure" access-list entries. This will get reworked for the final config.Having said that, I still don't see why I can't NAT from VLANs 2,3, or 4. Or, at the least, see which acces...
