Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need to collect Netflow data on some core switches (WS-C6513 and WS-C6509-E) with a WS-SUP720-BASE supervisor module, however I'm not able to find out any Cisco documentation informing whether or not Netflow feature can is available on this supervi...
I need to measure the current capacity on my Cisco devices in order to plan future required capacity based on the historical data and growth projection.So checking Cisco documentation in regards to the capacity planning subject, this documentation in...
I need to measure router/switch performance for capacity planning purposes.So I've been using the Router/Switch Switching Performance in Packets Per Second (PPS) getting the CISCO maximum values versus the data transferred on the device itself, but m...
I'm looking for acceptable CPU levels for all CISCO devices, for instance if the CPU or memory reaches 80% utilization I should start investigating because the performance of the device can be impacted.
Good morning.I'm looking for a way to identify the power source (AC or DC) on Cisco Catalyst switches 355024 and 295024.Is there any command I can use for identifying if the switch in question is AC or DC?
Thanks again for all attention and support.As far as I can understand my supervisor is “PFC3A mode”, which does not allow the bridged traffic capture.So I'd like to understand better what exactly that means?What exactly I'd be able to capture using m...
Thank you for all help and support.I'm a little bit confused on waht exactly means routed traffic and bridged traffic.Would you mind to help me to understand what exactly this kind of traffic means?
My concern is related to the supervisor module hardware because I was not able to find out the WS-SUP720-BASE datasheet. So I'm not sure whether or not this one includes the Netflow feature included.The IOS version running on our core switches is 12....
Thank you for the attention and help.How do I collect the device data to compare with the PPS rating indicated on the documents you provided?Should I get the PPS numbers on each interface and then sum up all of them to compare with the PPS rating?
