Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I made the mistake of clicking break HA which has disabled all the interfaces on my standby unit and disabled HA completely, I can no longer access it other than via the console which you cant see to do a great deal with.
Is there anyway to recov...
Hi,
I m really struggling to get 9164 access points to join a 9800 controller.
I get this error on the console of the Access point dtls_log_replay: dtls_log_replay: DTLS Replay Attack detected for Source.
I don't know if this is the reason for the AP...
Hi All,I am just doing some testing of a network due to be installed in a couple of weeks and have noticed what seems to be strange results with MST. I have some C3750G switches connected together running MST and these switches seem to think that th...
Hi All,I have an issue regarding Multicast. We recently upgraded a control system network using 3750G in a "ring" topology, which was running several types of traffic (CCTV:roughly 100 cameras, SOS telephones etc). Where we have been trying to intro...
Hi,
I have run the wireless config analyser there were a few minor issues regarding management access, but it didn't give any glaring issues?
Show cdp neighbors output:
Device ID Local Intrfce Holdtme Capability Platform Port IDAPC4D6.6636.F1B0 Two 1...
Hi,
Sorry I should have said that when it's set to BE it's still the same error, it thinks its set to DE. But when the controller is DE that error goes away but it still has the dtls replay attack message.
