About sajid231088

sajid231088 · 11-09-2019

Hi All, We have Cisco FPR 9300 deployed in Standalone. We are getting maximum Intrusion events " POP...

sajid231088 · 10-24-2019

Hi Mervin, Thanks for your response. Actually in our setup both IPS are standalone no HA. For one in...

sajid231088 · 10-24-2019

Hi All, Hope you all are doing well Need your help in finding interface down time.ok i will brief it...

sajid231088 · 09-22-2019

Hi all,Hope you all are doing good.Please help me on below.We have two FTD 9300 installed in our set...

sajid231088 · 07-23-2019

Hi All,Hope you all are doing goodPlease help me on the below..I have one Cisco 2800 series router, ...

sajid231088 · 07-18-2019

Thanks for your prompt response. Is there any model available of 12 or 18 ports in 9300 series ?

sajid231088 · 07-18-2019

Hi All,Hope you all are doing well. Please help me in getting the right switch for the below require...

sajid231088 · 03-04-2019

Hi All, I have setup for sponsor based guest access, All working fine but when guest puts its creden...

sajid231088 · 02-28-2019

Hi Team, Hope you all are doing good I am working on wireless guest access ( Sponsor Base ). I have ...

sajid231088 · 02-18-2019

PFA

sajid231088 · 02-18-2019

Hi Socratesp, Thanks for your prompt response. I have attached a diagram as per your suggestion, Ple...

sajid231088 · 02-18-2019

Hi All, Hope you all are doing well. Please help me in below. I have below devices : ASA 5525 (2 nos...

sajid231088 · 02-05-2019

Hi Jurgens, Thanks for your prompt response. Its very helpful for me, could you please share core sw...

sajid231088 · 02-05-2019

Hi All, Hope you all are doing good. I am new on ISE and facing many challenges first and most impor...

sajid231088 · 10-22-2018

Hi, Please try to change Anyconnect angent/ compliance module. Hope it would work. Regards Sajid Bai...

Snort: Re: IMAP and POP preprocessor do not handle TLS