About 3dmaxer

3dmaxer · 11-05-2024

I purchased the "CISCO DIRECT SL-900-SEC=" for my C9311 router (personal) and was able to install it, but I also want to have access to latest software release for the router.Can anyone tell me what I need to purchase so that I can get access to the ...

3dmaxer · 06-14-2024

Just noticed logs showing repeating stand-by selection messages that seem to be occurring every few minutes as shown below. All APs are on same switch, AP1 is set to preferred controller and I'm running latest EWC. Any ideas on what might be causin...

3dmaxer · 11-28-2023

I'm trying to get multicast to work between an SG550x switch and wireless devices connected to an embedded wireless controller setup with multiple 9115 access points. While I can get multicast to work across VLANs on the switch, I can't get multicas...

3dmaxer · 11-17-2023

I have two SSIDs AP1 and AP2 both of which leverage MAC authentication device list defined under AAA Advanced, Device Authentication. I have defined the Attribute List Name and WLAN profiles specific to each MAC in an attempt to limit the SSID that ...

3dmaxer · 09-13-2023

I previously had my RV340 router's WAN port connected to a Spectrum D3.1 eMTA modem at 1gb but have noticed that I'm now only seeing the WANs port speed connected at 100mb. To isolate the issue I connected the Spectrum modem to a switch which is set...

3dmaxer · 11-05-2024

Thanks Flavio. Would that be a smartnet agreement?

3dmaxer · 06-14-2024

All APs have been up for days and switch ports all show no errors. I'm on latest version 17.9.5.47.

3dmaxer · 11-28-2023

When I do a multicast test between two wired devices on VLAN 1 and do a sh ip igmp counters vlan 1, I get the following:vlan 1Elapsed time since counters cleared: 48:28:59Failed received Joins: 0Total IGMPv1 received messages: 0Total IGMPv2 received ...

3dmaxer · 11-28-2023

Yes, I had this configured for each of the VLANs (1,3,5) for static and selected all the ports that the APs were connected to. Here is that config:interface vlan 1name "Main - 10.50.1.x"ip address 10.50.1.5 255.255.255.0no ip address dhcpip dhcp rel...

3dmaxer · 11-28-2023

Yes, see below. I have all VLAN snooping set to v3, any thoughts if I need to use v2 for this situation? ip igmp snoopingipv6 mld snoopingip igmp snooping vlan 1ip igmp snooping vlan 1 immediate-leaveip igmp snooping vlan 2ip igmp snooping vlan 2 im...

Member Since	‎04-28-2022 03:58 PM
Date Last Visited	‎11-05-2024 07:53 PM
Posts	22
Total Helpful Votes Received	5

User Statistics

User Activity

Access to download rights for C911 router

stand-by selection events occurring every few minutes

SG550x multicast

MAC auth with WPA for specific SSIDs

RV340 router WAN port speed

Re: Access to download rights for C911 router

Re: stand-by selection events occurring every few minutes

Re: SG550x multicast

Re: SG550x multicast

Re: SG550x multicast