Missing nodes

[3dmaxer]

Installed CML free version, and then downloaded the Refplat file (refplat-20241016-freetier.iso), and mounted CD and then from the CML 2 System Maintenance Controls pressed the Copy Refplat ISO button.  Saw messages that showed files being copied, after which I went into Lab portal and did not see any of the additional nodes beyond the initial ones that came with base install.

Tried restarting Ubuntu for giggles - no additional nodes and no joy.  What am I missing here?

[Martin L]

there was same issue post at CLN CML group for more info at

https://learningnetwork.cisco.com/s/topic/0TO3i00000094ZjGAI/cisco-modeling-labs-personal-community

or check CML Docs pages

Regards, ML
**Please Rate All Helpful Responses **

[3dmaxer]

I'm not seeing any messages that apply to my situation.  The install I did was a new install and had the CD mapped to the unzipped file "refplat-20241016-freetier-iso" that from what I have seen published applies to a fresh install.  I watched it pick up the file and process it so I'm at a loss of what I might be missing here.

[@TinoMasawi]

please make sure you dont start the VM before applying the needed settings...correctly map the refplatform iso on the CD/DVD.

[balaji.bandi]

Not sure is this Limitation of Free Tier, never tried Free Tier.

check Do you have enough space  first ?

then follow the instructions. may be try creating new CML version Free tier and use general ISO to copy (instead of Free ISO)

just a suggestion to see if that works for you ?

https://developer.cisco.com/docs/modeling-labs/copy-refplat-iso-to-disk/