Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings community, I would like to set up routing on my ASA for about 80 subnets so that traffic to these subnets is routed to a specific interface. We would like to avoid using static routes so I need help in deciding the best alternative and als...
Greetings, I would like to NAT outgoing traffic only from a subnet ID 192.168.88.0/24 to a subnet ID 172.20.30.0/24 BUT only for traffic heading towards two partner subnets (10.20.40.0/24 and 172.20.95.0/24) without affecting outgoing traffic to othe...
Hello all,
I'm setting up a second public IP block for a different DMZ server. When I ping the Nated IP (31.80.169.227) from outside I'm getting the log "No translation group found for icmp src.." on my firewall. Any ideas on how to fix this will b...
Hi Everyone,
First off thanks for the priceless information this community provides to techies all over. I'm newish to IPSEC VPNs and have a question.
I have a DMZ host that's PATed to a public IP. I have set up an IPSEC tunnel (with an external org...
Hi BB,
Thanks for the response. They are in the original config had masked them out and left DMZ and outside configs since that's the challenge areas
Regards
MM
