The traffic between the loopback 0 interfaces of R1 and R2 should traverse through R3; R3 should be configured such that it translate 132.10.10.1 to 171.1.1.1 and 132.11.11.1 to 173.2.2.2 You can do NATTING only R3 router. After completing the sol...

 Configure OSPF Area 0 on all routers. and make the end to end connectivity.R5 to R2 is our Lease line link**********************************Set the traffic like this**********************************************when you do the traceroute from R1 to ...

 Part 1:------------------------------ we have r5 configuration below Copy the R5 router configuration and paste on your R5 router Note:: R5 is already configured...you will not change anything on R5 router Configure RIP Version 2 (RIPv2) between ...

                     task1- i am supposed to ping from R1 to R8 the route should go R1-R2-R4-R3-R5-R6-R8but it was going like this R1-R2-R4-R6-R8 task2- i am supposed to ping from R2 to R7 the route should go R2-R1-R3-R5-R6-R8-R7but it was going like...