Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,
I am currently trying to distribute IPv4 BGP Packets through my IPv6 Backend.
I am able form adjancencies between all "needed" Routers, however the Routes don't seem to be forwarded.
Current Configuration:
Left-breakout (A1-POP1)rout...
Hello guys,I am trying to implement MPLS in my A1(ISP in Austria) Backbone. The Backbone runs entirely on IPv6 Adresses + OSPFv3.My question is how I would be able to implement MPLS in this network. Do I need to enable LDPv6? If yes how do I do this...
I have two Catalyst 6880X-LE which I would like to VSS-Cluster.Is this possible by connecting two 10GiB/s Links and combining them into an etherchannel?Or do I need a special cable,Thanks in advance,Lorenz
Hello guys,can I connect an Nexus 7000 with linecard N7K-F248XP-25E: , to an Fortigate 140D via Twinax Cable:Cisco SFP-H10GB-CU3MThanks in advance,Lorenz
Hello guys,I am trying to connect to my Catalyst6880X-LE via SSH.The configuration looks like this:ip ssh pubkey-chainusername adminkey-stringssh-rsa AAAAB3NzaC1yc2EAAAADAQABAAACAQC82TSQRtkH+hJpGoOHmPGingp7S5a0KOxLz/0j52U474tPVpoF5bdtWZTYYvgn7oQ/ovOc...
And again, you are right.
I basically just had to tunnel through the Backbone.
int tun0desc DMVPN_to_other_POPsno shutip add 192.168.0.3 255.255.255.0tunnel source g0/0tunnel mode gre multipoint ipv6tunnel key 1ip nhrp authentication cisco123ip nhrp ...
