Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to have the 678 forward everything, not just all ports, but its external ip address too? Much like most cable routers do? I want the 678 to forward everything to my internal firewall, so my internal firewall has the internet routeab...
I have a customer trying to setup an ipsec tunnel with me and they are not sure if their device will support it and to be honest, i'm not sure either, but I am leaning towards no. I need a better answer than my gut feeling though.Here is the output ...
Hello all,I am having a problem with port forwarding on my 501. This is what I have entered:static (inside,outside) tcp interface https 172.17.x.x https netmask 255.255.255.255 0 0access-list acl_outside permit tcp any interface outside eq httpsacce...
Hello,I have a PIX 515E FO and it is st the factory defaults. I simply assigned an IP Address to the inside interface. I am trying to upgrade to 7.0, then 7.1(1), which is the version my UR is on. I can't even ping any host on the same subnet, I a...
Hello everyone,I am setting up a PIX515 FO. It is currently on the 6.3(5) software. My UR PIX is running 7.1(1)I want to upgrade my FO to the same version, but the upgrade sheet says it requires 128MB RAM to do so; it currently has 64MB. Can I upg...
I'm not really sure what I am looking for in that link, can someone be more specific and maybe post the proper commands that or what needs to occur? Thanks,
Sorry, I thought that was sufficient, here is the complete output.Cisco IOS Software, 1841 Software (C1841-IPBASE-M), Version 12.4(1c), RELEASE SO FTWARE (fc1)Technical Support: http://w...
Yes, that was copied directly out of the email i got from the cisco tech, and yes it works the same for specific host. It was a while ago so i don't remember if it was a bug or what, sorry.
I opened up a ticket with Cisco for this problem and the following cured my problem.access-list RDP_MSS permit tcp any anyclass-map RDP match access-list RDP_MSStcp-map tmap exceed-mss allowpolicy-map global_policy class RDP set connection advanced-...
