Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We are making sort of self-provisioning Portal for our SP that will offer the customers Cisco APs. Our Portal will use CPI API and customers will be able to do some actions for their own APs and SSIDs - change psk, create new ssid, change bandw...
Hi,
Is there a way to edit failure source pattern *not separator, but the pattern itself, to be like this / just Name both for AP and for Controller?
At the moment pattern is:
MAC Address:Name for AP
IP Address:MAC:Name for Controller
both MAC and N...
Hi,
We have Cisco Unified APs with WLC 8540 and CPI 3.1.5. WLC is forwarding traps to CPI.
Majority APs are mounted and will stay where they are for good. Some APs are temporary mounted for conferences, performances...and will be removed after few da...
Hi there,
We have an ISP with APs of 18xx, 28xx and 15xx on WLC 8540 and they also have CPI 3.1 proffesional appliance.
Is it possible to use compliance from CPI on unified AP, eg to check the conf and change it if some params are not in accordance...
I see you posted this much time ago, but I run into the same problem and at the end I came with this calc - total traffic is calculated as client throughput[Mbps]*3600s/8 ...
