Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,Does the VRF names and the L3 vni that we create in bgp-evpn should be same on both the VTEP's?Also, if I am using route-map to advertise the network via bgp should the tag value be also same?I am trying to pin from 100.100.100.1 to 1...
Hello Community,Hope this all finds you well. I have a scenario which I have attached with this discussion.So, I have hosts connected to the vtep' s as per the topology and I can ping from host A to B and vice-versa.Now if my host due to V-motion mov...
I have scenario where I have two hosts which are in the same broadcast domain and on the same leaf.And I am trying to ping from host A to host B the ping is successful but the initial arp request is getting encapsulated in VXLAN.Is that suppose to ha...
Hello Community,I hope this finds you well.I am have enabled ip pim sparse mode and ip ospf network point-to-point on physical interfaces. But I have enabled ip pim sparse mode only on loopbacks and no point-to-point on these interfaces. What I have ...
Hello Community,I hope this email finds you well. Can anyone please help as how does this RD value (32867) is gets generated in Vxlan BGP-EVPN. I used auto configuration for this and 1.1.1.3 is my vtep source IP.
@Pavel Tarakanov,When you say " tag value same in the ip address and statement and in route-map " can you share some example so I understand the statement correctly.
@Dawei, So, just a follow up question as GARP came into picture.I was trying one more scenario where I have two hosts connected on same VTEP and both the host (host A and host B) are in same vlan.Now each host is sending the GARP and that is getting ...
@Dawei, Thanks for clearing out my doubt. Also, do you know what's the mac aging timer in this case? If host A moves from VTEP1 to VTEP2, how long VTEP1 will keep the entry of host A?
