Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to bring up an IPSec tunnel between an ASR1002 and a 2821. The tunnel itself works. Only the 2821 shows hits against its access list. Only the 2821 shows packets being encrypted with no decrypted packets. I purchased the firewall and IPSe...
I recently upgraded code on a Cat 4006 with a SUP IV engine to Version 12.2(25)SG from Version 122-18.EW. The switch seems to be running at a higher CPU since the upgrade and doesn't handle broadcast traffic as well. This switch is my ROOT. It has re...
If I issue the command:sh ip bgp neigh x.x.x.x advertised-routes and I see that I am advertising a route to the neighbor ( my ISP ), under what circumstances would the route not be propagated throughout the Internet?
I am in the process of moving connections off of a Cat 4006 onto a stack of 3750s. On the 4006, I see no errors on the show interface command. I move the cable ( same exact cable ) from the 4006 to the 3750 and the port gets CRC and input errors.The ...
There is a firewall. All other clients work except for DSL users from Texas. I do not believe the firewall is at fault but I have not seen the logs during a actual failure.
