Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,i'm posting screenshots of my wifi config and i'd like to know if there are other settings to improve my AP 2600i wireless connection.i have a fiber connection of 1 Gbps (with ethernet cable cat 7 25mt i see in ookla speed test 978mbps!) with the ...
Hi, i'm still here...like @Rich R told me, latest firmware for many AP series have the "404 not found" bug, and also the ap3g2-k9w7-tar.153-3.JF15.tar for AP2600i has it! but i don't want the easiest way and i'm now asking you how to configure my acc...
Hi everyone, given the thousand problems encountered with the latest firmware upgrades of the **bleep** tim hub, I decided to try the very complicated Cisco world by buying an Aironet 2600 WIFI Access Point and then wanting to disable the wifi manage...
yes it has but it is too "far" and the signal is low to have a stable connection, but the problem are the wifi standards of this ap: a-b-g so it doesn't go faster than 54mbps....a gigabit fiber connection under a 54mbps ap (2,4ghz)....bad choice
hi leo, i tried but with yours indications i haven't improvements....my pc doesn't reach this ap in 5ghz, but it does the old one....a little poor this Cisco device....
i installed this ap3g2-k9w7-tar.153-3.JPM.tarmost of pages are ok but the one of ssid configuration no.... i followed this guidehttps://www.youtube.com/watch?v=JkUfTXuwj2U&t=332swithout doing reset after installation of new firmware. one advice, reme...
Nothing but for reflash this time i watnt to be sure to use the real last with less bugs possible. Or is there any reasons to stop at JK?Tnx well here i found a reason to not upgrade at JK:https://community.cisco.com/t5/wireless/cisco-air-sap-web-ui-...
