Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have several Data Centers, some with ACE 4710 appliances and some with CSM's used for application load balancing. Are either of these devices capable of inspecting which browser a user has and act upon it, for ex: a user with I.E. ver 6 load...
I have a question pertaining to how policies work on vservers on Cisco's CSM.If I configure a vserver with a policy and the policy has an access-list (client-group) mapped to it which directs traffic to a specific serverfarm however all reals in that...
Hello,I have a question on how to setup load balancing on my CSMs located in my Data Center Distribution Layer, which consists of 6509s running Hybrid with CSMs running 4.2(5).I need to load balance an application that is always sourced from (2) Citr...
Hello,I have a need to block access to a few specific devices on a vlan within my Data Center ServerFarm. I am going to create an access-list and apply it to the gateway interface for that vlan or vlan interface, which resides on the ServerFarm Dist...
Hello,I have a couple of CSMs in my ServerFarm Distribution Layer and am hoping someone could advise and help me, if possible.If I have a vserver with "sticky" applied and with a url policy applied in addition to a default serverfarm. Is there a way ...
Sachin,Thank you for taking the time to look at my request.PLease refrain from calling me your dear. It is not appropriate.SF1 and SF2 are very much part of this VIP through the policies (bounce1 and Bounce2) applied to the VIP. Citrix servers are ...
Sachn,Thank you for your response.Sorry, I neglected to show or say that I am using probes. Probes are setup for TCP 81.So my corrected question is what happens when the reals are in a probe failed state and are down? Will the policies under the vs...
