Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i am having REP configuration seem to be not configured properly. below is the config summery. I was running STP and removed to install REP. I am running IOS 15.0 on 3750 devices.
SW-1 configuration:
Interface gi1/1/1
Switchport mode trunk
Rep ...
Can someone please help me, i am looking for clarification and possible documentation on what is difference between C3KX-PWR-350WAC V03 & C3KX-PWR-350WAC V02. I have 3750x device and i know the V2 power supply is for secondary slot but why V3? shoul...
I attempt to crypto map MAP-VPN interface OUTSIDE I receive WARNING: crypto map has incomplete entries. Any recommendation here are the conf
ASA Version 8.4(2)
!
hostname ciscoasa
names
!
interface Ethernet0/0
switchport access vlan 2
!
interface Eth...
I need to configure NAT on ASA5506x 9.2(1) and I am having hard time. Has anyone seen this issue before? I have static network with 2 5506x that I am trying to pass traffic from the “inside Network” to the “outside” with static IP address that are on...
I wish, i am using Cisco packet tracer to replicate possible deployment before i deploy. i tried everything i know.
ciscoasa#sh crypto isakmp sa
There are no IKEv1 SAs
There are no IKEv2 SAs
ciscoasa#sh crypto ip
ciscoasa#sh crypto ipsec sa
Ther...
Morning Marius,
i tried to apply all of the commands above but i am unable to run the debug command on that ASA5505
Cisco Adaptive Security Appliance Software Version 8.4(2)
Device Manager Version 6.4(5)
Hey Dinesh,
Thank you for responding i tried removing and reapplying the crypto map MAP-VPN interface outside and it still giving me warring
crypto map has incomplete entries
