612
Views
0
Helpful
1
Replies
REP Configuration
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-31-2016 11:15 AM - edited 03-08-2019 07:15 AM
i am having REP configuration seem to be not configured properly. below is the config summery. I was running STP and removed to install REP. I am running IOS 15.0 on 3750 devices.
SW-1 configuration: Interface gi1/1/1 Switchport mode trunk Rep segment 1 edge Interface gi1/1/2 Switchport mode trunk Rep segment 1 edge primary SW2 configuration: Interface gi1/1/1 Switchport mode trunk Rep segment 1 edge Interface gi1/1/2 Switchport mode trunk Rep segment 1
SW3 Interface gi1/1/1 Switchport mode trunk Rep segment 1 edge Interface gi1/1/2 Switchport mode trunk Rep segment 1 SW4 configuration: Interface gi1/1/1 Switchport mode trunk Rep segment 1 edge Interface gi1/1/2 Switchport mode trunk Rep segment 1 SW5 configuration: Interface gi1/1/1 Switchport mode trunk Rep segment 1 edge Interface gi1/1/2 Switchport mode trunk Rep segment 1 SW6 configuration: Interface gi1/1/1 Switchport mode trunk Rep segment 1 edge Interface gi1/1/2 Switchport mode trunk Rep segment 1 edge
Labels:
- Labels:
-
Other Switching
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-12-2017 12:10 PM
Rep segment 1 edge in 5 interface in one segment is that not too much
