Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an old 2610 router. I have the laptop connected to the console port (with PuTTY if it matters), power on the router, wait to let it go through all the steps and give me a prompt, so I can rest it to the default configuration. The problem occ...
I want to know is there an easy way to import or read into an ASA a list of IP addresses? I can build a list of IP addresses and/or ranges, but since the list would be rather lengthy and to avoid typos, I do not want to have to type it all in by han...
I was wondering if someone would let me know what is currently considered best practice for ACL's on the ASA-5510? We want to add more rules to restrict access to the ASA and the LAN behind it. Would blacklisting or whitelisting be better?
The ASA-5...
I am wondering if NBAR or NBAR2 is supported on Catalyst 2960 switches? The pertinent versions are LANLite K9 12.2(50) SE2, LANLite K9 12.2(55) SE5, Universal K9 12.2(53) SE2, and LANBase K9 12.2(50) SE5. If someone can point me to the applicable d...
Ok, I got into rommon. I confreg 0x2142 and reset the router. It is still in a loop.
The router has not been in use since before I got here (been in storage). It also looks like the router has 64M of RAM. If that is true, then the text-base + da...
What I want to do is to use the list to deny access to the network from locations outside of the U.S. After all, they shouldn't have any legitimate interest in our site. If it causes problems, we could allow certain machines that have been shown to...
I have about half of them in a text file. I've been pulling them from various sources that match up with the official lists from ARIN so far.
The ideal way for us to do it would be to take the list of US IP numbers from ARIN, strip out the lines we...
