I'm implementing a controller for Openflow switches. We install some default flows upon switch connection - such as "Table 0 GOTO Table 1", "Table 1 GOTO Table 2", and so on. We also install a few flows like "Send ARP packets to the controller...
Well, a solution of sorts. The flow request above is standard compliant and of common format. But I found that the flow is accepted if the Instruction type is changed from "Write Actions" to "Apply Actions", which is also standard compliant, but ...
I have the exact same issue. I can set the switch to 'boot mode openflow' and reload successfully, but 'openflow' is not recognized as a keyword in config commands or show commands. When typing 'feature openflow' as per document instructions, th...