About ilay

ilay · 12-24-2020

Your authentication and authorization policy rely on AD username & Group, It is only credential to p...

ilay · 12-23-2020

Leave & rejoin the domain will not affect the existing policy settings, but all policies that rely o...

ilay · 12-22-2020

Yes,you are right. real speed depends on the transceiver you used

ilay · 12-22-2020

"Hardware" show the nexus LineCard or Nexus switch supported speed in hardware layer." full-duplex, ...

ilay · 12-22-2020

I have tested this problem. First, join all ISE nodes to a test domain controller, then disable the ...

ilay · 12-22-2020

You can use the following two commands to set the log and debug display time format service timestam...

ilay · 12-21-2020

You can just config a Dynamic PAT to solve this problemNAT subnet 172.16.0.0/24 to asa outside inter...

ilay · 12-21-2020

想要提高无线的接入速率，需要在WIRELESS->802.11a/n/ac/ax->RRM->DCA中将频宽（Channel Width）设置为40Mh或者更高。或者在WIRELESS->Access...

ilay · 12-20-2020

Change the svi interface address of the 2960 switch, keep the svi ID consistent with the subnet used...

ilay · 12-20-2020

默认情况下，刷完胖ap镜像启动之后登录web页面是使用的是enable密码在开启 ip http server时，同样也会提示修改先修改enable的密码，否则登录会出问题。ap(config)#ip...

ilay · 12-18-2020

你的意思是多台dns server共同维护cn.xxxx.net的记录，使用10.48.180.3/4这两个解析有问题，其他的解析正常？如果是这种情况的下就需要检查这两台dns的问题了，或者直接更换成...

ilay · 12-17-2020

看你的问题，发现个疑问点：ise去进行dns查询cn.xxxx.net的时候使用的是tcp，而解析zsm430-xxx.cn.xxxx.net的时候却正常使用的udp这点有点想不太通还有一些需要再进一...

ilay · 12-16-2020

非常好的总结。痩ap刷胖ap的时候，进去之后要迅速执行，稍有耽搁有可能传不完ap就因找不到controller强制重启了。被这个坑了好多次=_=

ilay · 12-16-2020

文档查找方法：查到对应的无线控制器型号，然后找对应型号支持的os版本，然后找Release Notes，在Release Notes中查看Supported Cisco Access Point P...

ilay · 12-15-2020

报错提示route-map h125中包含了不支持的选项（options），大概率是CAT3850不支持这种带选项的PBR，（也不支持verify-availability）那么只能尝试些set ip...

Date Registered	‎06-25-2015 01:31 AM
Date Last Visited	‎01-01-2021 03:30 AM
Total Messages Posted	180
Total Helpful Votes Received	351

Re: ISE 802.1X Double Auth (PC+USER) - Question about Local PC built-in Accounts