Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a switch CATALYST 2960-X SERIES that was not working. I had to replace this switch with another cisco. I tried to reset the switch 2960-X to factory configuration, witch my computer connected to console port, but there was a message tellin...
I think the file c2960x-universalk9-mz.152-7.E4 isn't working very well. Every time when I try to boot with this file, it's shown the messages below: Loading "flash:c2960x-universalk9-mz.152-7.E4"...flash:c2960x-universalk9-mz.152-7.E4: is a director...
- When I say the switch is in "Switch Mode", the prompt of the console is shown as bellow, and it's possible to execute the commands: The system has been interrupted prior to initializing theflash filesystem. The following commands will initializethe...
I couldn't replace the IOS. when I play the procedure (urn off the switch, push the button "mode" and turn on the switc), the switch doesn't start in a mode that I can run the procedure to replace the IOS. The IOS I want to transfer to Switch is c296...
Hello @Flavio Miranda, thanks for you attention,It was crashing and I couldn't configure it through the browser. I could only configure it by command line. I don't know if I'm correct but I read a documentation that say when we want to delete the co...
