Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have had to upgrade two of my 2504 WLC to code version 8.3.102.0 to support new APs with Domain B. The WLC's came with 7.6 which is deferred, so I tried the latest two ED releases 8.2 and 8.3 but then the GUI is almost unusable. I can only reliable...
I am trying to get a Symbol MC9060G with a new 2602e AP that is a stand-alone. I have configured the AP for WPA-TKIP with a PSK and it works fine on a laptop. The laptop can use this same profile on the old AP as well as this Cisco 2602e. The scann...
I have and ASA 5520 that is the device that all of our remote access connect with and it is the VPN tunnels for our backup connections if our MPLS circuits fail. Just recently I added a site that has a VPN tunnel only. The remote users connecting thr...
I have setup a new ASA 5515 with asa911-smp-k8 but my AnyConnect 3.1 can't complete the SSL connection. On the ASA side all I get is a message the SSL handshake is started with client outside...for TLSv1 session and then a No matching connection for ...
I am currently using a PAT overload statement to get public addresses on internet traffic.interface GigabitEthernet0/0.1encapsulation dot1Q 1 nativeip address 10.140.0.1 255.255.254.0ip flow ingressip flow egressip nat insideip virtual-reassemblyinte...
Nathan,
I didn't run the FUS update because I don't access the WLC much. I was waiting on a fix on a newer version, but I did go back to 8.0.140.0 on one controller which fixes the issue but I lose the new GUI screens. When I get a new WLC to install...
I know about the advanced button but that is the worst with the side and top menus not displaying about 40% of the time and the display not showing 80% of the time.
Here is the Sysinfo - I see Firmware PIC 20.0. Should I still upgrade to FUS 2.0.0.0 or do I have it already?
Manufacturer's Name.............................. Cisco Systems Inc.Product Name..................................... Cisco ControllerProdu...
I set the AP back to factory defaults and the scanner connected just fine. So I added just the configuration lines in the CLI to add WPA to that SSID and that worked also. I will have to be careful in the GUI because the data rate are what I think ca...
