Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Does anyone have any experience with the following setup:We want users to authenticate thru Dot1x with their Windows credentials. The RADIUS server for dot1x will be ACS that uses Windows DC for authentication. Then we would like for the ACS ...
I have 4 GB installed in 2951 but only 2 GB show up. Am I missing something?Total memory size = 4096 MB - DIMM0 = 2048 MB, DIMM1 = 2048 MBCISCO2951/K9 platform with 4194304 Kbytes of main memoryMain memory is configured to 72/72(dimm 0/1) bit mode w...
Hello everyone,We have a Cisco 2504 deployed here with 5 1131 APs. We have a WLAN setup with Layer3 web auth that hits an LDAP server. All that is working fine. The issue we have is iPhones that auto-associate to this WLAN. They are not authentic...
Hello,We have a 2504 Cisco WLC. I am creating Local Net Users for one of the WLANs that uses Web Auth and the Local Database.My one question is, what does a "guest account" do differently than a non guest account besides the ability to create the li...
Hello,I have a handful of brand new Cisco WAVE 294's and 594's. I need to downgrade the code from 4.4.5 to 4.4.3. I have the new code on my usb drive, which is readable by my laptop. However, when I plug the device into the 594 and run the "lsusb"...
Hello,
I am replying to an old thread so hopefully this works.
If we change from a 2110 Firepower that was locally managed by a FDM to a centrally managed one by FMC, do we lose only the policies/objects or do we lose all configuration? (interfac...
Can you configure a port on the Core Switch in access 613 and plug a host in and ping the gateway? another L3 SVI?
This will at least isolate the problem to the subnet/VLAN or to the access switch.
