Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I'm testing a new lab with FMCv and FTDv on 6.3.0-83 and having Management IP setup issues on FTDv. Followed the regular OVF deployment and setup on 1st login but cannot get fixed on interface. Tried to update se configure network ipv4 a...
Have any1 being able to use a Z1 to work as an additional Access Point in your networks ?Like you've purchased a Z3 and made the border router and want to leave Z1 just to enhance coverage in other room.
Hi all, Need to test accessing NX-OS fabric details thru ACI and found this one with a Nexus device. I can connect to it but cannot find it's credentials as the sandbox defaults admin/ciscopsdt are not valid on this device. Where can I get it?
Yes. I used that config to solve current need and future ones. As a simple change could be done only at ACL level and dont have to go thru a complete config analisys, create a new acl to the replace the one in use at nat statement, etc. I know that i...
Will consider that, thanks! Note that I avoided something more simple as need to connect from the outside to the external IP, like for ssh, and although not specifying dest/services, that will be ready for that later. What you did mentioned about log...
I'm using this and it's working fine : interface GigabitEthernet1description External interface with DHCPip address dhcpip nat outsidenegotiation auto!interface GigabitEthernet2description Trunk interfaceno ip addressnegotiation auto!interface Gigabi...
Any news on higher throughput on Z1 ?I'm going to 500Mbps now and although fast, these carriers' $%@#$ routers are so bad.Miss all my dashboards and controls from Z series.
