Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I have CSM configuration as below:! serverfarm OUTSIDE-SF no nat server no nat client predictor hash address real xxx.xxx.103.92 no inservice real xxx.xxx.103.93 inservice real xxx.xxx.103.91 inservice probe PING! sticky 1 netmask 25...
Hi, Because I want to change the "GRE" protocol timeout value , on the FWSM Command Reference 3.1, http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/mod_icn/fwsm/fwsm_3_1/fwsm_ref/t.htm#wp1259027 I find the "non_tcp_udp" syntax on the web...
Hi All, If I want switch send log for port up/down, When I using "logging event link-status" command in the port level configuration, the console and syslog server will receviced the port up/down message with port number, but this is difficulty to...
Hi All, In my lab environment, this command is required,(config-if)# power inline port max 20000 but you also must change the default CDP packet interval from 60sec to 5 sec, let AP receive the switch CDP packet when AP negotiate power level in ...
Hi Gilles, On the outofservice firewall, I can monitor the packet pass through firewall,I saw the icmp packet log on the firewall afterreal server configure to "no inservice" about 2 hours. by the way, I will try to create new vserver for icmp an...
Hi I known the "timeout" command , but the "non_tcp_udp" parameter is not exist on fwsm even though you can find "non_tcp_udp" on CCO documentation.Amber
In Taiwan,If you using xDSL connect to the ISP.Some ISP will disconnect your connection,when you idle to much time.Maybe you can ask your service provide.
