Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following kron backup set on my Catalyst 3850 switch:kron occurrence daily-backup at 1:00 recurring
policy-list dail-backup
!
kron policy-list daily-backup
cli show run | redirect ftp://192.168.96.65/3850Stack-config-$(TIMESTAMP).cfgBut ...
Hi All, we have a pair of Nexus9k switches set up in a single domain. Im running out of ports and still have lots of other hardware that i need to set up but not enough ports. I have another pair of Cisco Nexus3k switches..... I want to add them to t...
Hello everyone, i have two subnets configured as follows:I am using cisco Nexus 3548 Chassisversion 6.0(2)A6(7)interface Vlan21 no shutdown no ip redirects ip address 192.168.21.2/24 hsrp version 2 hsrp 21 ip 192.168.21.1 ip dhcp relay addre...
I have one existing network and just finished up building a new network. So I have network A (OLD) and network B (NEW). Two networks are totally isolated from each other.
I have lots of data that need to transfer from A to B, im thinking of connectin...
We have a Cisco 3845 router, which is connected to the uplink(internet) through FastEthernet1/0 Interface. Because we are maximizing bandwidth on this interface, almost 80% I have installed a Cisco Gigabit Ethernet HWIC with ' 1000BASE-T SFP ' in t...
Thanks Reza for the linkI also had this confirmed with a long colleague of mine, so the final set up will look like this:So on each switch I will have to create a PortChannel10, make ports member of this Po10 and also make Po10 a member of VPC10 on e...
Hi Paul, So I can successfully PXE boot from the same vlan (192.168.24.0) where the automation tool resides, but cannot PXE boot from any subnets. Here is an interesting thing. When attempting to PXE boot from another subnet say ( 192.168.21.0) Im do...
Hi Guys, sorry im a little late with the reply, been unexpectedly busy with other tasks...So for the dhcp.conf file in our linux machine we are using these settings:
# dhcpd.confomapi-port 7911;default-lease-time 43200;max-lease-time 86400;ddns-updat...
