Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got a SPA3102 connected to both the PSTN and SIP provider. All is working fine apart from a few little niggles.Whenever I dial out on the PSTN, it takes about 10 seconds to start hearing the ringing at the other end. Is this the 'PSTN Dialing De...
I've previously been running v3.something of the firmware which allowed you to set the FXS port impedance to 370+620||210nF which was the standard all the instructions told you to use for a UK BT Line.I've now upgraded to version 5.1.10 of the firemw...
I've read the Cisco document - 'Router and VPN configuration for Public Internet on a Stick COnfiguration Example' and I've got a couple of questions.Below is my config that I've built using the above example.... I know the VPN side of it works as i'...
HelloI've got a 2651xm router acting as an easy VPN server to allow me access onto my network - all works great.I'm living abroad and want to be able to configure the router to allow 'internet on a stick' functionality - by adding a loopback interfac...
I'm setting up CME4.1 with a vic-2fxs and vic-2fxo.I can get both working with IP and analogue phones.My issue is that whenever I get a call from the PSTN over FXO to an analogue phone, there is no caller-id - the phone just says 'Call'. I've read th...
OK, thanks. One final question.If im not translating the loopback ip through a static NAT translation, then what external ip address will the outside world see ?
Thank you for the quick response -When you say....'set ip next-hop 192.168.2.2' - where is this going as I've got nothing that has this ip address ??my internal network in 192.168.0.1 -my vpn network is 192.168.1.0 -my Loopback interface has 192.168....
Yes, you are correct in your confirmation of what I want to do, but I dont understand what I need to add to the configuration to allow me to do this.....Do I basically replicate the configuration that I already have but point it at the loopback inter...
Here is the output of my 'show diag' for the vocie ports......Slot 1: 4 PORT Voice PM for C2600 Port adapter Port adapter is analyzed Port adapter insertion time unknown EEPROM contents at hardware discovery: Hardwa...
Thanks Walter, but the problem is that none of the caller-id comands under the FXO port are recognised.I can get the 'caller-id enable' command for the FXS port but not the FXO port.
