About shaun.cooney

shaun.cooney · 07-24-2010

Hi everyone,I have recently switched my cable internet connection over to a Cisco C2621XM replacing my old Netgear ISP provided router. Before the switch my internet was lightning speed. When I clicked "Home" or entered a URL I would have the site fu...

shaun.cooney · 06-06-2010

Hi,I have a HQ and a remote site and I want to get a site-to-site VPN running between the two. I have the following config on each router. "Show crypto session" says that the VPN is in a UP-IDLE state (and from my somewhat limited understanding of VP...

shaun.cooney · 07-26-2010

Hi Brandon,Thanksd for your reply. Yes you are correct, that was my previous setup although the Netgear router acted as both a router and a switch for a while until I needed more capacity.I am currently plugged directly into the Router using an x-ove...

shaun.cooney · 07-25-2010

Try issuing show ip nat translations. Are there any translations active? I suspect not.If not try debug ip nat 1 and post some results.

shaun.cooney · 07-25-2010

In your VPN TCP/IP properties in Windows select the Networking Tab and select properties of TCP/IPv4.Then select Advanced abd untick the default "Use Default Gateway on Remote Network"Hope that helps

shaun.cooney · 06-06-2010

Perfect. Worked great. Thanks Federico

Member Since	‎06-04-2010 02:19 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	6

User Statistics

User Activity

Slow Internet Using 2621XM

S2S IPSec VPN Problems

Re: Slow Internet Using 2621XM

Re: PAT with puplic ip over ADSL

Re: Internet connection lost after VPN established

Re: S2S IPSec VPN Problems