Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone.
I thought this was much simpler than it is turning out to be... I am trying to achieve something that should be quite simple: an AS that originates some routes, and passes some along from other ASes.
For routes originating from this AS, ...
Hi everyone,
Have an issue which I hope has a simple solution, but I cant seem to find it.
I acquired an 887VA-W which has a built in AP802GN. Ive taken an almost literal copy of the config off my 1242AG and put it on to the AP inside the 887 and Im ...
Hi everyone.Im testing out some configuration in my lab where I am attempting to use a Cisco 3825 for PSTN simulation and dialup termination.In this 3825 I have a VIC2-2BRI-NT/TE configured to emulate network, and connected to this is a WIC-1B-S/T-V3...
Hi All,Apologies if this is not the right forum, I couldn't find one for hardware (if this is indeed a hardware fault...)I have a number of 2811 and 3745 routers which I am trying to link back to back (at this stage) in my lab for staging, they will ...
Hi all.I am wondering if anyone is able to comment on the maximum number of NM-1A-E3's you can get into a 3745.Documentation suggests the "maximum recommended" is 2, but I am wondering if it is possible to install 3 and whether the router will identi...
Novel solution to make it work with a single route-map.
Having got it working now, I think I will stick to using individual route-maps per address family.
Thanks!
Tom
Hi Paul,
I'll have a look in to this as its not something Ive come across before. But it would seem that mixing IPv4 and IPv6 operations in to the same route-map entry is a no-no in general, and likely what was causing my problem.
I suppose I dont un...
Small update, becuase maybe this matters, but I think I might have found part of the problem.
In my route map I have 3 clauses:
1. tries to match prefixes with an IPv4 prefix-list
2. tries to match prefixes with an IPv6 prefix-list
3. tries to match ...
What kind of serial adapter and cable are you using, and have they been confirmed to work with other devices?
Where did the router come from, and was it known to be working?
What do the LEDs on the front of the unit do after powering on?
With default...
After a bit more playing I have managed to successfully establish data calls through the VIC-2BRI, but what I had to do was to use a VoIP dial peer to another router where I have an E1 VWIC which is then in turn connected to the 3825.In this configur...
