Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a CAT6509 with MPLS.. two redundant MSFC2 blades. Whenever I go in to configure one of the MSFC's I get the message:%MROUTE-4-MTU_MISMATCH : WARNING: With IP multicast enabled, interfaces which transmit traffic from larger to smaller MTU inte...
I have a 4402 WLAN controller with 4 wlans setup on it. One of them has open security for "hotspot" type access. Users connect and when they open their web browser they are prompted by a login page for authentication. The user accounts are setup o...
Hello all. I am going a bit crazy over here trying to work out some network issues with Dell. I have a few Dell PowerEdge servers connected to a:10/100/1000BaseT Ethernet WS-X6148-GE-TXAll servers are running 1.0GB NICs. Some say that I should use...
I have a question on CATOS that I am sad to ask. I have a command set on an interface:set vlan 203 3/4How can I undo this command? I know this is a silly question but I cannot find reference anywhere! Thanks.
I am having some issues with the initial setup of a 4402 WLC and 35 Cisco Aironet LWAPPs. The WLC and the LWAPPs are configured in the same VLAN and a DHCP server is setup to serve the VLAN. The WLC is configured for LAYER2. The LWAPPs show link l...
I contacted Cisco directly and it turns out this is a "debug" type message and I do not have to worry about it. Just an FYI for anyone who reads this.- Bill
dancampb,Thank you for your post. I understand what you are saying. How is it that I set/control the session and idle time? Is it a problem if I look at changing these settings?Thanks,Bill E.
Hello all again. I took a look further at my configs. All servers are set to auto in the NIC software. The switch is set to AUTO for duplex and 1000 manually for speed. I can change the speed back to AUTO. However, the ports/interfaces have 0 er...
